Humidity and Temperature Room Sensor
EE10
Highly accurate, long term stable humidity and temperature room sensor for residential and commercial HVA
EE10 humidity and temperature sensor with display, EU standard
EE10 humidity and temperature sensor, EU standard
EE10 humidity and temperature sensor with display, US standard
EE10 humidity and temperature sensor, US standard
The very stylish EE10 enclosure is available in European and US size and in several colours. The snap-on concept allows for easy installation. The active part of the device can be replaced within seconds without any tools.
The measured data is available on two 4 – 20mA or 0 – 10V outputs, on the Modbus RTU or the BACnet interface, as well as on the optional display.
Key Features
- Measurands: water activity aw, temperature T and water content x in ppm
- High accuracy and long term stability
- Elegant design
- Easy installation and service
- Analogue, Modbus RTU or BACnet output
- High accuracy and long term stability
Technical Data
| Measuring range 0...95% RH -5...55 °C (23...131 °F) | Accuracy ±2% RH ±0.25 °C (±0.45 °F) |
| Outputs 0-10V or 4-20mA, Modbus RTU, BACnet | Supply 24 V AC / DC |
Related products
EE10-T
EE800
Downloads EE10
Support literature
EU Declaration of Conformity
FAQ
What is the difference between Modbus RTU and Modbud TCP/IP
The main difference is the hardware interface. The Modbus RTU protocol runs on RS485 Hardware while Modbus TCP/IP protocol on Ethernet hardware.
What is the different between a 2 wire and 3 wire current output?
Transmitter with “two-wires” technology receive the power from the process, and the signal is carry on return wire (closed current loop). With technology “three-wires” the power supply is separate from current output: 2 wires are the power supply and third carry the signal.